V.35 to Ethernet Converter RCN- 100

RCN- 100 provides a new level of performance in connecting a V.35 Modem or interface to the LAN with out using expensive Router.

RCN-100 can convert data stream from Ethernet interface to V.35 & vice –versa.

Specification

System Application

·        Enterprise solution for the connectivity of various user interfaces across Telecom carrier network.

·        LAN Extension.

·        Router/Bridge connectivity.

           User interface(10/100 Base –T Ethernet)

·        Fully compatible with Ethernet & IEEE 802.3 standards.

·        Supports standard HDLC protocol.

·        10 Base – T (RJ-45), IEEE 802.3.

·        Dynamically learning and aging up to 2048 MAC addresses.

·        MAC address filtering enhances security & bandwidth.

              V.35 interface

·        The V.35 interface is synchronous, high speed digital DET type. It uses multi –wires to carry data and control signals.

             Digital Interface

·        Ethernet via RJ45 connector

·        V.35 via DB25 pin female connector.

·        Band rates configurable as per a clock at V.35 terminal up to 4 Mbps.

Async to sync converter RCN-200AS

RTS - RCN-200AS  Converter is designed to perform conversion of synchronous data and clock signals to an asynchronous data signal. Converter works on power derived form interface, no External power source is required. The RS-232 side supports direct connection to the DB25 connector with standard pin out and V.35 also support standard 34 pin V.35 connector.

FeaturesZ

·        No external power source, works on power derived from interface.

·        No switch selection, Plug and play.

·        Can convert any standard V.35 DCE port into RS232 async.

NEXT>> 1,2,3,4,5,6