|
E1
& Ethernet Circuit Emulation gateway RTDMIP –
100/400
Real
time TDM over IP products RTDMIP–100/400 a highly
integrated Circuit Emulation Services (CES) gateway that
multiplexes a single /four E1 circuit and100Mbps user
Ethernet data onto any Ethernet/P network or link. The
Realtime RTDMIP – 100/400 uses field proven clock
recovery technology. The RTDMIP–100/400 includes
G.823/G.824 compliant synchronization and supports fine
control Of delay, throughput and payload size while
handling mis-ordered packets and packets delay variation (PDV).
The RTDMIP – 100/400 also strictly prioritized TDM
traffic over user Ethernet traffic. Out-of-band TDM
signaling and farming mode is also supported for increased
robustness
Features
-
Fully
integrated CES over packet gateway
-
Complies
with CES o PSN & SAToP
-
Built
– in G.823/G.824 compliant synchronization
-
Adaptive,
External, internal and loopback timing
-
1
/ 4 Unstructured ,full or fractional E1/T1 ports
-
Two
first Ethernet ports
for WAN uplink & user Ethernet
-
Strictly
prioritized TDM circuit emulation
-
Standard
SNMP MIBS Minimized Ethernet packetization mode
-
Out
-of- band signaling and framing modes
-
Field
– proven performance
-
Point
– to – point and point to multipoint topologies
-
E1
Transmission
Circuit
Emulation protocol
: IETS/SAToP,IETF/CESoP
and minimal Ethernet header configurable
Minimum
internal delay
:
0.7ms
Packet
size :
64 to 1496byte configurable
Signaling :
Transparent or guaranteed out of system delivery
Delay
Jitter Buffer
:
0-800 ms configurable
Standard
SNMP MIBS
:
ITU- T Rec. G.703,G.706, G.732, G823
Framing
:
CRC4, MF ,CAS MF
Data
rate (per port)
:
2.048 Mbps
Line
code : HDB3,AMI
Clock
Distribution
;
Clocking
option :
Loopback, adaptive , external configurable
Ethernet
traffic processing
:
Rate
limiting : 0-100
Mbps configurable in Kbps increments
VLAN
tagging
:
QOS 802. 1q,802lp
Ethernet
:
Interfaces : Auto-
negotiating 10/100 Mbps MII/RMII(X2)
Standard
:
IEEE802.
Management :
Ethernet
:
Local- UART/Ethernet, Remote- Ethernet
User
client
:
CLI over UART or Telnet
NEXT>> 1,2,3,4,5,6
|